Emerson Rosemount 2090P Reference Manual page 66

Rosemount 2088 and 2090
5-6
www.aotewell.com
Message
Device write protected. Do you
still want to
shut off?
Display value of variable on
hotkey menu?
Download data from
configuration memory to device
Exceed field width
Exceed precision
Ignore next 50 occurrences of
status?
Illegal character
Illegal date
Illegal month
Illegal year
Incompatible CPU board and
module ON
Incomplete exponent
Incomplete field
Looking for a device
Local buttons operator error ON
Mark as read only variable on
hotkey menu?
Module EEPROM write failure
ON
No device configuration in
configuration memory
No Device Found
No hotkey menu available for
this device.
No pressure updates ON
No offline devices available.
No simulation devices available. There are no device descriptions available to simulate a
No temperature updates ON
No UPLOAD_VARIABLES in ddl
for this device
No Valid Items
OFF KEY DISABLED
Online device disconnected
with unsent data. RETRY or OK
to lose data.
sales@aotewell.com
Reference Manual
00809-0100-4690, Rev FC
Description
Device is in write-protect mode. Press YES to turn the
Field communicator off and lose the unsent data.
Asks whether the value of the variable should be
displayed adjacent to its label on the hotkey menu if the
item being added to the hotkey menu is a variable.
Press the SEND softkey to transfer information from the
communicator memory to the device.
Indicates that the field width for the current arithmetic
variable exceeds the device-specified description edit
format.
Indicates that the precision for the current arithmetic
variable exceeds the device-specified description edit
format.
Select YES to ignore the next 50 occurrences of device
status, or select no to display every occurrence.
An invalid character for the variable type was entered.
The day portion of the date is invalid.
The month portion of the date is invalid.
The year portion of the date is invalid.
Upgrade the electronics board or the sensor module to
the current revision.
The exponent of a scientific notation floating point
variable is incomplete.
The value entered is not complete for the variable type.
Polling for multidropped devices at addresses 1–15.
Illegal pressure applied during zero or span operation.
Repeat the process after verifying the correct pressures.
Asks whether the user should be allowed to edit the
variable from the hotkey menu if the item being added to
the hotkey menu is a variable.
Message sent to the module from the HART signal failed.
Replace the transmitter.
There is no configuration saved in memory available to
re-configure off-line or transfer to a device.
Poll of address zero fails to find a device, or poll of all
addresses fails to find a device if auto-poll is enabled.
There is no menu named "hotkey" defined in the device
description for this device.
No pressure updates being received from the sensor
module. Verify that the sensor module ribbon cable is
attached correctly. Or replace the transmitter.
There are no device descriptions available to be used to
configure a device offline.
device.
No temperature updates being received from the sensor
module. Verify that the sensor module ribbon cable is
attached correctly. Or replace the transmitter.
There is no menu named "upload_variables" defined in
the device description for this device. This menu is
required for offline configuration.
The selected menu or edit display contains no valid items.
Appears when the user attempts to turn the HC off before
sending modified data or before completing a method.
There is unsent data for a previously connected device.
Press RETRY to send data, or press OK to disconnect
and lose unsent data.
Industry Automation
June 2011
+86-755-8660-6182