Assembly And Usage - aoyue Int936A Instruction Manual

ASSEMBL Y and USAGE
I. SOLDERING IRON STAND
1. Assemble Soldering iron stand.
①
②
2. Dampen the cleaning sponge with water, squeeze it dry and
place it in its base.
II. SOLDERING IRON
1. Attach the soldering iron to the receptacle connector at the
bottom right area of the main unit.
2. Place soldering iron to the soldering iron stand as shown in Fig. 1
3. Plug the power cord into a receptacle with ground.
III. MAIN UNIT
1. Turn on unit.
2. When the heater lamp blinks on and off then it means that the
tip temperature has reached the set temperature and is ready for
use.
6
③
Soldering iron must be
placed in the iron holder when
not in use.
BASIC TROUBLESHOOTING GUIDE
WARNING: To avoid personal injury or equipment damage,
disconnect power cords before making any servicing to the
equipment, or unless
troubleshooting procedures.
PROBLEM 1: THE UNIT HAS NO POWER /MAIN POWER LED DOES NOT
LIGHT UP
1. Check if the unit is switched ON.
2. Check the fuse. Replace with the same type of fuse if blown.
3. Check the power cord and make sure there are no disconnections.
4. Verify that the unit is properly connected to the power source.
Additional precautions :
Check internal circuitry for shorts that may cause the blown fuse. See
◆
"Troubleshooting Connections"
Check for tangles of wires in the heating element causing it to short.
◆
See "Troubleshooting Connections"
PROBLEM 2: SOLDERING IRON DOES NOT RISE IN TEMPERATURE
Description: Main power LED lights up and so does the heater LED but
soldering iron temperature is relative low and is not heating up.
SOLUTION:
Soldering iron cord may be damaged and needs to be replaced or
repaired. See "Troubleshooting Connections"
Heating element may be damaged and needs to be replaced see
the Heating Element"
on page 11 and
12 on this manual.
instructed otherwise in the
on page 13-15.
on page 13-15.
on page 13-15 of this manual.
"Testing
"Replacing the Heating Element"
on page
19