Specification - aoyue Int936A Instruction Manual

BASIC TROUBLESHOOTING GUIDE Aoyue 936 规格
PROBLEM 3: SOLDERING IRON TEMPERATURE IS INTERMITTENT
Description: Main power LED lights up and so does the heater LED but
soldering iron temperature rises and falls uncontrollably.
SOLUTION:
Soldering iron plug may be loose from the receptacle unplug the
◆
soldering iron and reattach.
Soldering iron cord may be damaged or loose and needs to be
◆
replaced or repaired. See trouble shooting soldering iron cords
section of this manual.
PROBLEM 4: SOLDER WOULD NOT STICK TO THE SOLDERING TIP
Description: Soldering iron is able to quickly melt solder but cannot cause the
solder to attach to the tip.
SOLUTION:
Soldering iron tip may already be too dirty or oxidized . Please see
◆
our solder tip maintenance guide on how to clean soldering tips.
Temperature could be set too high causing solder to quickly burn
◆
away, Please adjust to a more suitable lower temperature range.
PROBLEM 5: SOLDERING IRON DOES NOT PRODUCE ENOUGH HEAT
Soldering iron cannot melt solder fast enough, or actual
Description:
temperature does not reach the desired set temperature.
SOLUTION:
The system may need to be recalibrated please see
◆
calibrating the tip temperature
Soldering iron tip may already be too dirty or oxidized . Please see
◆
our solder tip maintenance guide on how to clean soldering tips.
20
steps in
on page 9 of this manual.

SPECIFICATION

Int936A / 936A
Model#
Power Consumption
Fuse
MAIN STATION
Output Voltage
200—480 °C
Temperature Range
392—896 °F
110(w)×93(l)
Dimension
×168(h) mm
SOLDERING IRON
24V—60W
Power Consumption
Tip to Ground
Less than 2 Ohm
Resistance
Tip to Ground
Less than 2 Ohm
Potential
PTC Heating
Heating Element
Element
Power Cord 1.1 meters
1.2 meters
Length
108 grams
Weight
Design and specification might change without prior notice.
Int936 / 936
60W 35W
1A 0.5A
24V 24V
200—480 °C
392—896°F
110(w)×93(l)
×168(h) mm
24V—60W
Less than 2 Ohm
Less than 2 Ohm
Ceramic Heating
Element
1.1 meters
1.2 meters
100 grams
5