Gira G1 Installation Manual page 23

01
Place the holding frame on the
flush-mounted connection module.
02
Straighten the holding frame.
03
Mark the drilling position for the
holding frame.
04
Drill the holes in the wall for the
holding frame.
05
Insert the supplied dowels into the
drilling holes.
06
Fix the holding frame using the
cylinder head screws M3 × 10
[see Fig. 16 [22]].
07
Tighten the screws for the dowels
[see Fig. 16 [23]].
The holding frame is fastened.
3 Mounting the device
Fig. 16
Screwing in the holding frame
[22] [23]
23