Fisher & Paykel EB60 User Manual page 38

!5
INSERT WATER TANK: Place the
water tank back in the appliance.
!8
EMPTY DRIP TRAY: At the end of rinsing, remove, empty and replace the drip tray
and grounds container. Press NEXT.
!9
DESCALE COMPLETE: press
@0
FILL TANK WITH FRESH WATER: empty the container used to collect the rinse water,
remove the water tank and fill with fresh water up to the MAX level, then place the
water tank back in the appliance.
@1
Descaling is complete.
Note:
If the descaling cycle is not completed correctly. For example if there was a
●
power cut, we recommend repeating the cycle.
After descaling, it is normal for the grounds container to contain water. If the water
●
tank has not been filled to the MAX level, at the end of descaling, the appliance
requests a third rinse to guarantee that the descaler solution has been completely
eliminated from the machine's internal circuits. Before starting the rinse cycle,
remember to empty the drip tray.
The appliance may request descaling cycles at very short intervals. This is due
●
to the appliance's advanced control system and is part of normal operation.
36
DESCALE
!6
POSITION 2L CONTAINER OK TO
START RINSING: Place the
container used to collect the
descaler solution empty under the
hot water/steam spout and press
!7
Hot water is delivered from the
steam spout and RINSING UNDERWAY
is displayed.
.
.