Fisher & Paykel EB60 User Manual page 33

Cleaning the infuser
The infuser must be cleaned at least once a month.
IMPORTANT!
The infuser must not be removed when the appliance is on. Do not use force
to remove the infuser.
1
Make sure the machine is correctly turned off (see Turning off).
2
Open the service door.
3
Remove the drip tray and waste
coffee container.
IMPORTANT!
Do not use dishwashing liquid to clean the infuser as it will remove the lubricant
inside the piston.
5
Soak the infuser in water for about five minutes, then rinse.
6
After cleaning, replace the
infuser by sliding it onto the
internal support and pin at
the bottom, then push the
PUSH symbol fully in until it
clicks into place.
CLEANING
4
Press the two coloured release
buttons inwards and at the same
time pull the infuser outwards.
Note: if you encounter
difficulty inserting the
infuser, before inserting
it you must adapt it to
the right dimension by
pressing it forcefully
from the bottom and
top as shown.
7
Once inserted, make
sure the two coloured
release buttons have
snapped out.
8
Replace the drip tray
and waste coffee
container.
9
Close the service door.
31