Club Car Carryall 295 Owner's Manual page 52

Engine Oil Filling
Figure 53 Coat Rubber Seal
1. Add engine oil; use a funnel or pour spout to direct the oil into the opening (Figure 54). With filter change,
the engine requires 3 qt. (2.8 L) for diesel vehicles. Refer to oil viscosity guidelines for selection of oil
grade (Figure 55). See following CAUTION.
CAUT ION
• Do not exceed recommended oil capacity. Doing so will decrease engine performance or
result in damage to the engine.
2. Connect the battery cables, positive (+) cable first, and tighten terminals to 144 in-lb (16 N·m). Coat ter-
minals with Battery Terminal Protector Spray (CCI P/N 1014305).
3. With the Forward/Reverse handle in the NEUTRAL position, start and run the engine for a few minutes.
Observe both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If a leak is
detected, check the tightness of the oil filter and drain plug. Tighten, repair, and/or replace components
as necessary.
NOTE: Wait five minutes after turning off the engine before removing the dipstick.
4. Remove the dipstick and check the engine oil as a final step. Replace the dipstick.
OIL VISCOSITY
Choose the viscosity according to the temperature as shown in the appropriate oil viscosity chart (Figure 55).
See following NOTE.
NOTE: Use engine oil with API classification CF for diesel engines.
Page 50 2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner's Manual
Figure 54 Add Engine Oil – Diesel Vehicles
Engine Oil