Club Car Carryall 295 Owner's Manual page 26

3. Study and understand controls.
4. Be sure all passengers are seated with safety belt fastened and holding on to hand holds. Driver should
have both hands on the steering wheel.
5. Make sure wheels are turned in desired direction and nothing is in your path.
6. Make sure the Forward/Reverse handle is in the NEUTRAL position.
7. Press and hold the brake pedal.
8. To start the vehicle:
8.1. To preheat glow plugs in cold weather, turn the key to the PREHEAT position and hold for 10-15
seconds. Then turn the key all the way to the START position and hold until the engine starts. If the
engine does not start after 10-15 seconds, return the key to the OFF position and repeat the pro-
cedure. Once the engine starts, release the key and it will return to the ON position. The engine will
idle in neutral.
9. In cold weather, allow the engine to warm before using any attachments. Once the vehicle is warm,
increase the engine RPM and cycle the attachment arm several times.
10. Pull the joystick backward to raise the attachment arm only high enough to clear obstructions on the
ground.
11. Release the park brake.
12. While keeping the brake pedal engaged, select direction of travel by placing shift handle in desired posi-
tion (Figure 4, Page 11). Engine must be at idle before moving shift handle. A buzzer will sound as a
warning when the Forward/Reverse handle is in the REVERSE position.
13. Release the brake pedal completely, and then slowly press the accelerator pedal. As the accelerator
pedal is pressed, the vehicle will begin to move, and speed will increase until full speed is reached. All-
wheel drive will automatically drive appropriate wheel(s) as required. See following WARNING.
ý
WARNING
• Operator must control vehicle speed when going downhill.
• Never shift the vehicle out of the FORWARD position while going downhill. If you do, you will
not be able to shift into the REVERSE position or back into the FORWARD position until
stopped.
• Press the brake pedal as necessary and press the accelerator pedal partially when
descending a hill. With the accelerator pedal partially pressed, the governor will cause the
engine to assist the brakes in controlling downhill speed.
ALL-WHEEL DRIVE (AWD) OPERATION
The Carryall 295 IntelliTach and XRT 1550 IntelliTach vehicle features an all-wheel drive (AWD) system. The
AWD system automatically directs power to the wheel, or wheels, that have the most traction, providing opti-
mum traction at all times. For example, if all wheels except the rear passenger-side wheel lose traction, then
power will be directed to the rear passenger-side wheel. The all-wheel drive vehicle can adapt traction for a
wide variety of driving surfaces and conditions. See following WARNING.
Page 24 2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner's Manual
Driving Instructions