Club Car Carryall 295 Owner's Manual page 38

ACTIVATE
TOGETHER
FOR FLOAT
Figure 41 Joystick
7. Swing the attachment interface cylinder down.
8. Turn the key to the ON position but DO NOT start the engine.
9. Move the joystick (1) forward to extend the attachment arm cylinder (Figure 41).
10. Move the joystick (1) to the right to extend the attachment interface cylinder.
11. Turn the key to the OFF position.
NOTE: When aligning the cylinders to the attachment arm and interface during installation, the cylinders
may need to be retracted slightly to relieve the hydraulic pressure. Do not have hands in the area
of the cylinders when extending or retracting the cylinders.
12. Raise the attachment arm (1) and align it with the cylinder (2). Install the pin (3) and retaining ring (4)
(Figure 42).
13. Raise the attachment interface and align it with the cylinder. Install the pin (2) and the retaining ring (1)
(Figure 43).
Figure 43 Raise Interface, Install Pin and
Retainer Ring
Page 36 2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner's Manual
FLOAT
1
AUX HYD
Figure 42 Raise Attachment Arm, Install Pin, and
Retainer Ring
Attachments and Buckets