Club Car Carryall 295 Owner's Manual page 31

ý
WARNING
• Before you leave the operator's seat:
- Put Forward/Reverse handle in NEUTRAL.
- Engage the park brake.
- Stop the engine.
- Turn the key switch to OFF.
9. Move the attachment interface lever (1) fully to the right and into the locked position (Figure 19).
NOTE: If the lever does not engage in the locked position, see your dealer for maintenance.
10. If equipped, connect the hydraulic hoses from the attachment to the vehicle. See Quick Couplers (If
Equipped) on page 17.
11. The attachment interface pins (1) (both sides) must extend through the holes in the mounting frame of
the bucket (or attachment), securely fastening the bucket or attachment to the attachment interface
(Figure 20).
ý
WARNING
• Attachment interface pins must extend through the holes in attachment with lever in the
locked position. Failure to secure pins can allow attachment to come off and cause serious
injury or death.
Figure 20 Interface Pins
Removing an Attachment
1. Tilt the attachment at least half way back and slightly off of the ground. If the attachment is hydraulically
controlled (i.e.: snow blade, etc.), stop the engine and relieve hydraulic pressure in the auxiliary circuit.
See Relieve Hydraulic Pressure on page 17.
2. Stop the engine, put the Forward/Reverse Handle in NEUTRAL, engage the park brake, unfasten your
seat belt, and exit the vehicle.
3. Disconnect the hydraulic hoses, if equipped. See Quick Couplers (If Equipped) on page 17.
4. Pull the attachment interface lever (1) fully to the left and into the unlocked position (Figure 21).
2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner's Manual
Figure 21 Interface Lever in Unlocked Position
Attachments and Buckets
Page 29