Club Car Carryall 295 Owner's Manual page 36

Figure 33 Remove Attachment Cylinder Retaining Pin
4. Remove the retaining ring (1) and the pin (2) from the attachment arm cylinder rod end (Figure 33).
5. Turn the start key to the ON position but DO NOT start the engine.
6. Retract the attachment arm cylinder fully by moving the joystick (1) back (Figure 34).
7. Retract the attachment interface cylinder fully by moving the joystick (1) to the left.
8. Turn the start key to the OFF position.
9. Rotate the attachment arm cylinder (1) vertically against the mount (2) (Figure 35).
10. Install the existing pin (3) and retaining ring to secure the cylinder to the mount.
11. Rotate the attachment interface cylinder (5) upward against the vehicle and snap it into place (8).
12. Install the existing pin (6) and retaining ring (7) in the locking hole on the mounting plate.
13. Remove the 2 retaining rings (1) and pins (2) from the attachment arms and mounting plate (Figure 36).
14. Lower the attachment arms to the ground.
15. To store, install the pins (1) into the attachment arm holes (both sides) and secure with the retaining pins
(Figure 37).
Figure 35 Secure Attachment and Interface Cylinders
Page 34 2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner's Manual
ACTIVATE
TOGETHER
FOR FLOAT
AUX HYD
Figure 34 Joystick
Figure 36 Remove Attachment Arm Retaining Pins
Attachments and Buckets
FLOAT
1