Club Car Carryall 295 Owner's Manual page 30

INSTALLING AND REMOVING AN ATTACHMENT
Installing an Attachment
ý
WARNING
• The attachment interface lever has spring tension. Hold lever tightly and release slowly.
Failure to obey warning can cause injury.
Figure 16 Attachment Interface Lever
1. Pull the attachment interface lever (1) fully to the left and into the unlocked position (Figure 16).
2. Enter the vehicle and fasten the seat belt.
3. Start the engine and disengage the park brake.
4. Press the joystick ON/OFF rocker switch (18) to ON (Figure 4).
5. Lower the attachment arm and tilt the attachment interface forward.
6. Drive forward until the front edge of the attachment interface is completely under the top lip of the bucket
(or attachment) (Figure 17).
7. Tilt the attachment interface backward until the cutting edge of the bucket (or the attachment) is slightly
off the ground (Figure 18).
8. Stop the engine, put the Forward/Reverse Handle in NEUTRAL, engage the park brake, unfasten your
seat belt, and exit the vehicle.
Figure 18 Tilt Backward
Page 28 2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner's Manual
Figure 17 Position Interface under Top of Attachment
Figure 19 Lock Attachment
Attachments and Buckets