Compound Cutting - Makita DLS714 Instruction Manual

Compound cutting

Compound cutting is the process in which a bevel
angle is made at the same time in which a miter angle
is being cut on a workpiece. Compound cutting can be
performed at the angle shown in the table.
Miter angle
Left and Right 45°
Right 50°
Right 55°
Right 57°
Cutting crown and cove moldings
Crown and cove moldings can be cut on a compound miter
There are two common types of crown moldings and one type
angle crown molding and 45° wall angle cove molding.
1
1.
molding 3. 45° type cove molding
( a) ( b)
1. Inside corner 2. Outside corner
Bevel angle
Left 0° - 45°
Left 0° - 40°
Left 0° - 30°
Left 0° - 25°
2 3
2. 45° type crown
( c ) ( d)
1 2
1
(b)
(a)
(b)
(a)
1. Inside corner 2. Outside corner
Measuring
of the workpiece's wall contact edge is the same as wall
length.
4
1. Workpiece 2. Wall width 3. Width of the work-
piece 4. Wall contact edge
saw angles.
When cutting crown and cove moldings, set the bevel
position the moldings on the top surface of the saw
base as indicated in the table (B).
In the case of left bevel cut
1. Inside corner 2. Outside corner
19 ENGLISH
(a)
(b)
(a)
(b)
(d)
(c)
(a)
(b)
2
3
1
( a) ( b) ( c ) ( d)
1 2
2