Makita DLS714 Instruction Manual page 12

Adjusting the miter angle
1
3
1. Turn base 2.
5. Grip
1. Loosen the grip counterclockwise.
2.
scale as a guide.
3.
CAUTION:
After changing the miter angle,
always secure the turn base by tightening the grip
NOTICE:
When turning the turn base, be sure to
raise the handle fully.
Adjusting the bevel angle
the tool counterclockwise.
1. Lever 2. Release button
To tilt the blade to the left, hold the handle and tilt the
the arm.
2
4
5
3. Miter scale 4. Lock lever
1
1.
To tilt the blade to the right, hold the handle and tilt the
carriage to the left slightly, and push the release button.
With the release button pressed, tilt the saw blade to
the right. Then tighten the lever.
CAUTION:
always secure the arm by tightening the lever
clockwise.
NOTICE:
handle is fully raised.
NOTICE:
sure to position the kerf boards appropriately
as explained in the "Positioning kerf boards"
section.
Adjusting the lever position
If the lever does not provide full tightening in course of
time, change the position of the lever. The lever can be
repositioned at every 30° angle.
Loosen and remove the screw that secures the lever.
Remove the lever and install it again so that it points
slightly above the horizontal. Then, tighten the lever
1
2
1. Lever 2.
12 ENGLISH
1
2
2. Bevel scale 3.
After changing the bevel angle,
When tilting the saw blade be sure the
When changing bevel angles, be
3
2