Carrying Tool; Groove Cutting; Maintenance - Makita DLS714 Instruction Manual

3
1. 2. Holder 3.
right side of the groove in the kerf board, and while holding
workpiece. Then secure the set plate with the screw.
When the set plate is not used, loosen the screw and
turn the set plate out of the way.
NOTE:
accessory) allows cutting repetitive lengths up to
2,200 mm approximately.

Groove cutting

WARNING:
Do not attempt to perform this type
of cut by using a wider type blade or dado blade.
blade could lead to unexpected cutting results and kickback
WARNING:
Be sure to return the stopper arm to
the original position when performing other than groove
cutting.
incorrect position could lead to unexpected cutting results and
1.
ing screw and the stopper arm to limit the cutting depth of the
2.
cut parallel grooves across the width of the workpiece
using a slide (push) cut.
1
1. Cut grooves with blade
3. Remove the workpiece material between the
grooves with a chisel.

Carrying tool

1
and storage purposes and should never be used
for any cutting operations. The use of the stopper
pin for cutting operations may cause unexpected
movement of the saw blade resulting in kickback and
2
before carrying the tool. If portions of the tool move
or slide while being carried loss of control or balance
1.
2.
base at the full right miter angle position.
3.
is locked in the position of the carriage fully pulled to
operator and the upper poles are locked in the position
of the carriage fully pushed forward to the guide fence.
4.
position by pushing in the stopper pin.
5.
base. If you remove the holders, dust bag, etc., you can
-
carry the tool more easily.

MAINTENANCE

sharp and clean for the best and safest perfor-
mance.
may cause kickback and result in a serious personal
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
21 ENGLISH
WARNING:
Stopper pin is only for carrying
CAUTION:
Always secure all moving portions
Remove the battery cartridge.
Lower the handle fully and lock it in the lowered
Carry the tool by holding both sides of the tool
WARNING:
Always be sure that the blade is
CAUTION:
Always be sure that the tool is
Never use gasoline, benzine, thinner,