Makita DLS714 Instruction Manual page 20

Table (A)
– Molding Bevel angle
position
52/38°
in the
type
(a) Left
inside 33.9°
corner
(b)
(c)
outside
(d)
corner
Table (B)
– Molding
position in
(a)
corner
(b)
(c)
corner
(d)
Example:
Lay crown molding with its broad back (hidden) surface
EDGE against the guide fence on the saw.
Cutting aluminum extrusion
1. Vise 2.
extrusion 5.
When securing aluminum extrusions, use spacer blocks
when cutting the aluminum extrusion to prevent build-up
of the aluminum material on the blade.
Miter angle
45° type 52/38° 45° type
type
Left 30° Right Right
31.6° 35.3°
Left Left
31.6° 35.3°
Right Right
31.6° 35.3°
Molding Finished
edge against piece
guide fence
Ceiling
contact edge piece will be
should be on the Left
against guide side of blade.
fence.
Wall contact
edge should
be against
piece will be
guide fence.
on the Right
Ceiling side of blade.
contact edge
should be
against guide
fence.
1
2
3
4
5
3. Guide fence 4.
CAUTION:
Never attempt to cut thick or round
aluminum extrusions. Thick aluminum extrusions may
come loose during operation and round aluminum extru-
Wood facing
WARNING:
the guide fence. The screws should be installed so that the
screw heads are below the surface of the wood facing so that
they will not interfere with the positioning of the material being
cut. Misalignment of the material being cut can case unexpected
movement during the cutting operation which may result in a loss of
CAUTION:
Use the straight wood of even
thickness as the wood facing.
using the holes in the guide fence.
gested wood facing.
15m m ( 5/ 8" )
35m m
( 1- 3/ 8" )
92m m
1
( 3- 5/ 8" )
1. Holes
NOTICE:
When the wood facing is attached, do
not turn the turn base with the handle lowered.
Cutting repetitive lengths
When cutting several pieces of stock to the same
length, ranging from 220 mm to 385 mm, use the set
plate (optional accessory). Install the set plate on the
20 ENGLISH
Use screws to attach the wood facing to
420m m ( 16- 1/ 2" )
27m m ( 1- 1/ 16" )
85m m
100m m 70m m
( 3- 15/ 16" ) ( 2- 3/ 4" ) ( 3- 3/ 8" )
-
50m m - 60m m
( 2" - 2- 3/ 8" )
1