Switch Action - Makita DLS714 Instruction Manual

Switch action

WARNING:
Before installing the battery cartridge
on the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when
released. Operating a tool with a switch that does not actuate
WARNING:
Do not use a lock with a shank or
cable any smaller than 6.35 mm (1/4") in diameter.
tool in the off position and unintentional operation
WARNING:
NEVER use tool without a fully oper-
ative switch trigger.
WARNING:
lock-off button which prevents the tool from unintended start-
ing. NEVER use the tool if it runs when you simply pull the
switch trigger without pressing the lock-off button.
in need of repair may result in unintentional operation and
WARNING:
NEVER defeat the lock-off button
by taping down or some other means.
a negated lock-off button may result in unintentional
NOTICE:
Do not pull the switch trigger hard
without pressing in the lock-off button. This can
cause switch breakage.
For tools with blade guard release lever
To prevent the switch trigger from being accidentally pulled,
a lock-off button is provided. To start the tool, push the blade
guard release lever up, press in the lock-off button and then
pull the switch trigger. Release the switch trigger to stop.
The lock-off button can be pressed from either right or left.
padlock to lock the tool off.
3
1. Blade guard release lever 2.
3. Lock-off button 4. Hole for padlock
For tools without blade guard release lever
To prevent the switch trigger from being accidentally pulled, a lock-off
button is provided. To start the tool, press in the lock-off button and
pull the switch trigger. Release the switch trigger to stop.
The lock-off button can be pressed from either right or left.
padlock to lock the tool off.
ASSEMBLY
off and the battery cartridge is removed before working on
the tool.
Hex wrench storage
the hex wrench is needed it can be pulled out of the
wrench holder.
it to the wrench holder.
2
4
Installing or removing saw blade
1
switched off and the battery cartridge is removed
before installing or removing the blade.
start up of the tool may result in serious personal
provided to install or remove the blade.
tightening of the hex socket bolt. This could cause
13 ENGLISH
1
1. Lock-off button 2.
padlock
WARNING:
Always be sure that the tool is switched
1. Wrench holder 2. Hex wrench
WARNING:
Always be sure that the tool is
CAUTION:
Use only the Makita hex wrench
2
3
3. Hole for
2
1