Introduction To Elements - GE B90 Instruction Manual

5 SETTINGS
 SETTINGS
 TESTING
In the design of UR relays, the term element is used to describe a feature that is based around a comparator. The compar-
ator is provided with an input (or set of inputs) that is tested against a programmed setting (or group of settings) to deter-
mine if the input is within the defined range that will set the output to logic 1, also referred to as "setting the flag". A single
comparator may make multiple tests and provide multiple outputs; for example, the time overcurrent comparator sets a
pickup flag when the current input is above the setting and sets an operate flag when the input current has been at a level
above the pickup setting for the time specified by the time-current curve settings. All comparators use analog parameter
actual values as the input.
An exception to this rule is digital elements, which use logic states as inputs.
NOTE
Elements are arranged into two classes, grouped and control. Each element classed as a grouped element is provided with
six alternate sets of settings, in setting groups numbered 1 through 6. The performance of a grouped element is defined by
the setting group that is active at a given time. The performance of a control element is independent of the selected active
setting group.
The main characteristics of an element are shown on the element logic diagram. This includes the inputs, settings, fixed
logic, and the output operands generated (abbreviations used on scheme logic diagrams are defined in Appendix F).
Some settings for current and voltage elements are specified in per-unit (pu) calculated quantities:
pu quantity = (actual quantity) / (base quantity)
For current elements, the 'base quantity' is the nominal secondary or primary current of the CT.
For voltage elements the 'base quantity' is the nominal primary voltage of the protected system which corresponds (based
on VT ratio and connection) to secondary VT voltage applied to the relay.
GE Multilin
 REMOTE OUTPUTS
 DNA BIT PAIRS
 REMOTE OUTPUTS
 UserSt BIT PAIRS
 RESETTING

 DIRECT INPUTS

 DIRECT OUTPUTS

 IEC 61850
 GOOSE ANALOGS
 IEC 61850
 GOOSE UINTEGERS
TEST MODE
FUNCTION: Disabled
TEST MODE FORCING:
On
 FORCE CONTACT
 INPUTS
 FORCE CONTACT
 OUTPUTS
B90 Low Impedance Bus Differential System
5.1 OVERVIEW
See page 5-122.
See page 5-123.
See page 5-123.
See page 5-124.
See page 5-124.
See page 5-127.
See page 5-128.
See page 5-129.
See page 5-129.
See page 5-130.
See page 5-131.

5.1.2 INTRODUCTION TO ELEMENTS

5
5-3