GE B90 Instruction Manual page 117

Ur series low impedance bus differential system
Hide thumbs Also See for B90:
Table of Contents

Advertisement

4 HUMAN INTERFACES
3.
Repeat step 2 for the remaining characters: r,e,a,k,e,r, ,#,1.
4.
Press ENTER to store the text.
5.
If you have any problem, press HELP to view context sensitive help. Flash messages will sequentially appear for sev-
eral seconds each. For the case of a text setting message, pressing HELP displays how to edit and store new values.
d) ACTIVATING THE RELAY
RELAY SETTINGS:
Not Programmed
To change the
RELAY SETTINGS
1.
Press the MENU key until the
display.
2.
Press the MESSAGE RIGHT key until the
3.
Press the MESSAGE DOWN key until the
4.
Press the MESSAGE RIGHT key until the
SETTINGS
 SETTINGS
 PRODUCT SETUP
5.
After the
RELAY SETTINGS:
selection to "Programmed".
6.
Press the ENTER key.
RELAY SETTINGS:
Not Programmed
7.
When the "NEW SETTING HAS BEEN STORED" message appears, the relay will be in "Programmed" state and the
In Service LED will turn on.
e) ENTERING INITIAL PASSWORDS
The B90 supports password entry from a local or remote connection.
Local access is defined as any access to settings or commands via the faceplate interface. This includes both keypad entry
and the faceplate RS232 connection. Remote access is defined as any access to settings or commands via any rear com-
munications port. This includes both Ethernet and RS485 connections. Any changes to the local or remote passwords
enables this functionality.
To enter the initial setting (or command) password, proceed as follows:
1.
Press the MENU key until the
display.
GE Multilin
When the relay is powered up, the Trouble LED will be on, the In Service LED off, and
this message displayed, indicating the relay is in the "Not Programmed" state and is safe-
guarding (output relays blocked) against the installation of a relay whose settings have
not been entered. This message remains until the relay is explicitly put in the "Pro-
grammed" state.
: "Not Programmed" mode to "Programmed", proceed as follows:
header flashes momentarily and the
SETTINGS
PASSWORD SECURITY
INSTALLATION
RELAY SETTINGS:
 PASSWORD
 SECURITY
 DISPLAY
 PROPERTIES
 INSTALLATION
Not Programmed message appears on the display, press the VALUE keys change the
RELAY SETTINGS:
Programmed
header flashes momentarily and the
SETTINGS
B90 Low Impedance Bus Differential System
4.3 FACEPLATE INTERFACE
PRODUCT SETUP
message appears on the display.
message appears on the display.
Not Programmed message is displayed.
NEW SETTING
HAS BEEN STORED
PRODUCT SETUP
message appears on the
RELAY SETTINGS:
Not Programmed
message appears on the
4-25
4

Advertisement

Table of Contents
loading

Table of Contents