GE B90 Instruction Manual page 125
Ur series low impedance bus differential
system
Hide thumbs
Also See for B90:
- Instruction manual (510 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (442 pages)
Table of Contents
Advertisement
5 SETTINGS
If the setting and command passwords are identical, then this one password allows access to both com-
mands and settings.
NOTE
c) REMOTE PASSWORDS
The remote password settings are only visible from a remote connection via the EnerVista UR Setup software. Select the
Settings > Product Setup > Password Security menu item to open the remote password settings window.
Proper passwords are required to enable each command or setting level access. A command or setting password consists
of 1 to 10 numerical characters and are initially programmed to "0". The following procedure describes how the set the com-
mand or setting password.
1.
Enter the new password in the Enter New Password field.
2.
Re-enter the password in the Confirm New Password field.
3.
Click the Change button. This button will not be active until the new password matches the confirmation password.
4.
If the original password is not "0", then enter the original password in the Enter Password field and click the Send
Password to Device button.
5.
The new password is accepted and a value is assigned to the
If a command or setting password is lost (or forgotten), consult the factory with the corresponding Encrypted Password
value.
GE Multilin
Figure 5–1: REMOTE PASSWORD SETTINGS WINDOW
B90 Low Impedance Bus Differential System
item.
ENCRYPTED PASSWORD
5.2 PRODUCT SETUP
5
5-7
Advertisement
Table of Contents
