Table of Contents
Advertisement
Chapter 2
Riser Card Installation
1.
Align the riser card with the PCI-E golden finger
connector.
2.
Insert the card into the connector firmly.
3.
Fasten the screws to fix the card onto the board.
2
3
Front Ethernet Module Installation
1.
To install the front Ethernet module, take off the front
bracket first by unscrewing the threaded screws at the
bottom of the case.
2.
Insert the Ethernet module into the front expansion
slot. You should a click when the module connects to
the Riser Card.
3.
Fasten the screw back at the bottom of the case to
secure the module on the system.
Network Application Platforms
Introduction
7
Advertisement
Table of Contents
