Table of Contents
Advertisement
Chapter 2
1
3
2
8
Note:
The CPU heat sink can only be installed in only
1.
one orientation as shown in the picture.
To protect the CPU socket pins, retain the CPU
2.
cap when the CPU is not installed.
Network Application Platforms
5
4
7
Riser Card Installation
1.
Align the riser card with the PCI-E golden finger
connector.
2.
Insert the card into the connector firmly.
3.
Fasten the screws to fix the card onto the board.
2
3
Front Ethernet Module Installation
1.
To install the front Ethernet module, take off the front
bezel first by unfastening the threaded screws at the
bottom of the case.
2.
Insert the Ethernet module into the front expansion
slot. You should hear a click when the module connects
to the riser card.
3.
Fasten the screw back on the bottom of the case to
secure the module on the system.
Introduction
7
Advertisement
Table of Contents
