Front Panel Features - Lanner FW-8760 User Manual

Table of Contents

Chapter 1

Front Panel Features

F1 Power/Status/HDD LED

Power: If the LED is on it indicates that the system is powered on. If it is off, it indicates that the system is powered off.

Status: If the LED is green, it indicates that the system's operational state is normal. If it is red, it indicates that the system

is malfunctioning.

HDD:

If the LED is on, it indicates that the system's storage is functional. If the LED blinks, it indicates data access activities.

If it is off, it indicates that there is no hard disk present or functional.

F2 System Panel: LCD System Panel

The LCD System Panel can be programmed to display operating status and configuration information. For more details

or sample programming code, please refer to the User's Manual CD.

F3 Reset Switch

The reset switch can be used to reboot the system without turning off the power.

F4 Console Port

By using suitable rollover cable or RJ-45 to DB-9 Female (Cisco console cable), you can connect to a computer terminal

for diagnostic or configuration purpose. Terminal Configuration Parameters: 115200 baud, 8 data bits, no parity, 1 stop

bit , no flow control.

F5 Two USB 2.0 Ports

It connects to any USB devices, for example, a flash drive.

F6 Management Port

This FastEthernet port can be connected for configuration or troubleshooting purpose. A conformity with IPMI (Intelligent

Platform Management Interface) can be implemented through OPMA on this interface.

F7 7 Gigabit LAN ports

Right LED:If the LED is orange, it indicates that the connection speed is 1000Mbps. If the LED is green, it indicates that the

connection speed is 100Mbps. And if it is off, it indicates that the speed is 10Mbps.

Lefts LED: If the LED is on, it indicates that the port is active. If it blinks,

Using suitable RJ-45 cable, you can connect FW-8760 System to a computer, or to any other piece of equipment that

has an Ethernet connection; for example, a hub or a switch. Moreover, 3 pair (LAN1-LAN2, LAN3-LAN4, LAN5-LAN6) can

be configured as LAN Bypass when failure events occur. This feature is implemented in hardware using watch dog timer

functionality. Refer to your User's Manual CD for a sample implementation of this feature.

F8 LAN 8, LAN 9: An optional expansion of LAN switch. This expansion of LAN switch can add up to additional 8 Ethernet

ports.

Note:

The availability of LAN Bypass varies depending on the model.

The number of LAN ports varies depending on the model.

The management port is optional depending on the model.

Network Application Platforms

Manage LAN1 LAN2 LAN3 LAN4 LAN5 LAN6 LAN7

it indicates there is traffic.

Introduction

Table of Contents