Simulation - Emerson Rosemount 2240S Reference Manual

™
F Fieldbus Block Information
OUNDATION
October 2017
C.2.1

Simulation

To perform lab test of process variables and alerts, you can either change the mode of the AI block to
manual and adjust the output value, or you can enable simulation through the configuration tool and
manually enter a value for the measurement value and its status. In both cases, you must first set the
SIMULATE switch (1) on the field device to the ON position, see
With simulation enabled, the actual measurement value has no impact on the OUT value or the status.
164
Reference Manual
00809-0100-2240, Rev DA
"Switches and reset buttons" on page
™
F Fieldbus Block Information
OUNDATION
62.