CODELOCKS CL600 Installation Instructions Manual page 11

Back to Back and PK Versions
Back to Back and PK versions - Models CL600/610/615BB &
CL600/605PK
A) The CL600 range is available in Back to Back versions where the
code is on both sides of the door.
To install the Back to Back versions:
Follow instructions as for non back to back versions substituting the
backplate and handle 2, with the coded plate with the through fixing
holes.
Please note that each side may be coded with the same or different
codes.
B) The CL600 range is also available to work with most single point
panic pads or bars. In this format the front code plate only is
supplied with suitable fixing to connect to most single point panic
pads and latches. If in doubt ask.
To install the PK versions:
Step 1.
The position of the CL600PK on the door is determined by the
position of the panic device.
Step 2.
Mark the position of the spindle hole for the panic device on both
sides of the door.
Step 3.
Place the CL600PK gasket against the door with the 20mm ( / ")
hole centred over the mark for spindle hole. Using the gasket as a
3
template mark the 3 x 10mm ( / ") holes for the through fixing bolts.
8
Repeat on the other side of the door.
Find more online at www.codelockssupport.com
Step 4.
3
Drill the 1 x 20mm ( / ") hole and the 3 x 10mm ( / ") drilling holes,
from both sides to avoid splintering out the face of the door.
Step 5.
Countersink the bottom fixing hole as necessary so that the fixing
bolt lies flush with the door face, underneath the panic device.
Step 6. Fit the lever handle to the CL600 front plate and tighten the
grub screw in the handle. Enter the code of the CL600 front unit and
check that the lever will turn fully – see page 6. operation check.
Step 7.
Fit the CL600 front unit with the 3 fixing bolts. Insert the spindle with
the flat blade into the CL600 front unit, ensuring that the blade is at
the correct angle for the hand of door - see diagram page 8.
Step 8.
Install the panic device and make sure that the CL600 front unit will
fully retract the latch or bolt.
3
4
Page 11
3
4 8