Table of Contents
Advertisement
Connect and configure the CDD
C
onnect the CDD
In order to operate the system, the CDD must be plugged into an electrical outlet and connected to a computer
or router. The type of connection can be:
•
Cabled - The CDD is equipped with an Ethernet port and can be directly connected to a PC or router. A
direct connection to a computer should only be used during configuration of the system to access the local
web server, not for regular monitoring. A cabled connection to a router can be used during configuration
and for data transmission to access CDD internal configuration pages (local web server).
•
Wireless - The CDD is equipped with a wireless network card that can be connected to a router. This type
of connection can be used during configuration of the system to access the CDD internal configuration
pages (local web server) and for data transmission to the web portal in order to monitor the system.
The wireless connection of the CDD to the computer requires the use of a wireless router acting as a
"bridge" for the transmission of data. The configuration of the wireless network is done on the CDD display
using the panel buttons described below.
Turn on the CDD by attaching the power supply connector to the
bottom of the CDD and plugging into an electrical outlet; wait for the
green LED to come ON.
The UP and DOWN buttons are used to move around inside a menu
or to scroll through a list of settable values.
UP
The UP and DOWN buttons pushed together will open the three main
DOWN
menus.
ESC
The ESC button returns the user to the previous submenu when
navigating.
ENTER
The ENTER button is pressed to make a selection or to confirm an
entered value/parameter.
- 15 -
4
Hide quick links:
Advertisement
Table of Contents
