Page 1
® Product Manual ABB i-bus EIB / KNX Data Logging Unit BDB/S 1.1 Intelligent Installation Systems...
Page 2
Despite checking that the contents of this document match the hardware and software, deviations cannot be completely excluded. We therefore cannot accept any liability for this. Any necessary corrections will be inserted in new versions of the manual. Please inform us of any suggested improvements. E-mail: eib.hotline@de.abb.com...
(in hours) and counting operations on up to 35 channels. Limit values are defined for the individual counter values which automatically ® initiate an alarm message on the ABB i-bus if they are exceeded. Data logging can be used for example, to co-ordinate the maintenance expenditure and to determine the operational life of different devices.
2 space units. The Data Logging Unit enables you to count the switching operations of ® switch actuator channels in an ABB i-bus system. Furthermore, the operating hours of the connected loads can be recorded with a resolution of up to one second.
35 channels. The BDB/S 1.1 is operational after of the bus voltage. The module is programmed directly via ® the application program ETS. The connection to the ABB i-bus established via the bus connection terminal at the front of the device. Fig. 1: BDB/S 1.1...
Application program Note: ETS is required for programming. If ETS3 is used a “.VD3” type file must be imported. The application program is available in the ETS under ABB/Safety and Monitoring/Controller. Circuit diagram 2CDC 072 053 F0006 Fig. 2: Circuit diagram...
Commissioning requirements In order to commission the Data Logging Unit, a PC with ETS and a ® connection to the ABB i-bus , e.g. via a RS232 interface or a USB interface is necessary. The device is ready for operation after connection to the bus voltage.
Need help?
Do you have a question about the i-bus BDB/S 1.1 and is the answer not in the manual?
Questions and answers