YASKAWA V1000 Installation Manual page 33

3.
Tighten the cable gland caps.
4.
Connect the wires to the main and control circuit terminals.
Reattaching the Front Cover
■
1.
Insert the LED operator cable into the correct port on the drive. Refer to the
Figure 10.
2.
Replace the front cover on the drive and fasten the screws according to
NOTICE: Tighten all screws to the specified tightening torque. Loose screws may allow moisture or dust to
enter the protective enclosure and damage drive components.
NOTICE: Do not pinch or damage the sealing gasket when attaching the front cover. Damage to the gasket
may allow moisture or dust to enter the protective enclosure and damage drive components.
NOTICE: Do not use silicone sealant with cable glands or front cover to reinforce waterproofing. Corrosive
vapors produced by the sealant can damage circuit boards and compromise the watertight integrity of the
protective enclosure.
NOTICE: Do not pinch the LED operator cable between the waterproof/dustproof enclosure and the front
cover when putting the front cover back on. This could damage the operator cable.
Front Cover Screws and Tightening Torque
■
Refer Table 16 for tightening torque specifications.
Table 16 Front Cover Installation Screws and Tightening Torque
Voltage Class
Single Phase 200 V Class
Three Phase 200 V Class
Three Phase 400 V Class
YASKAWA ELECTRIC TOBP C710606 35D YASKAWA AC Drive - V1000 NEMA Type 4X/IP66 Installation Manual
Model No. CIMR-V
BA0001 to BA0012
2A0001 to 2A0020
2A0030 to 2A0069
4A0001 to 4A0011
4A0018 to 4A0038
6 Electrical Installation
Tightening Torque
Installation
Screw Size
M5 2.0 to 2.5 (17.7 to 22.1)
M5 2.0 to 2.5 (17.7 to 22.1)
M6 5.4 to 6.0 (47.8 to 53)
M5 2.0 to 2.5 (17.7 to 22.1)
M6 5.4 to 6.0 (47.8 to 53)
Table 16.
Nm
(lb-in)
33