Communicating Via Ethernet; Step 1: Configure Datalogger; Devconfig Setup - Campbell NL116 Instruction Manual

4.2

Communicating via Ethernet

4.2.1 Step 1: Configure Datalogger

a.
b.
c.
FIGURE 4-2. DevConfig setup
d.
NOTE A temporary IP address may be obtained from a DHCP server.
For more information, see Section 7.1.8, DHCP
NL116 Ethernet and CompactFlash
Connect serial cable from PC COM port to the datalogger RS-232 port.
Open Campbell Scientific's Device Configuration Utility (DevConfig).
Select the Device Type of the datalogger (CR1000 or CR3000), the
appropriate Communication Port, and Baud Rate. Connect to the
datalogger.
Under the TCP/IP tab, input the IP Address, Subnet Mask, and IP
Gateway. These values should be provided by your network
administrator.
Alternatively, note the Eth IP address assigned to the datalogger via
DHCP. However, note that this address is not static and may change.
Press the Apply button to save the changes and then close DevConfig.
® Module
.
(p. 19)
3