Electrolux EKC6450AOX User Manual page 29

A
Minimum distances
Dimension
A
B
13.3 Levelling of the appliance
Use small feet on the bottom of
appliance to set the appliance top
surface level with other surfaces.
13.4 Anti-tilt protection
CAUTION!
Install the anti-tilt protection
to prevent the appliance
from falling under incorrect
loads. The anti-tilt protection
only works when the
appliance is put in a correct
area.
Your appliance has the
symbols shown on the
pictures (if applicable) to
remind you about the
installation of the anti-tilt
protection.
B
A
mm
2
685
CAUTION!
Make sure you install the
anti-tilt protection at the
correct height.
Make sure that the surface behind the
appliance is smooth.
1. Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
2. Install the anti-tilt protection 77 mm
down from the top surface of the
appliance and 49 mm from the left
side of the appliance into the circular
hole on the bracket. See the
illustration. Screw it into the solid
material or use applicable
reinforcement (wall).
3. You can find the hole on the left side
at the back of the appliance. See the
illustration. Lift the front of the
appliance (1) and put it in the middle
of the space between the cupboards
(2). If the space between the bench
cupboards is larger than the width of
the appliance, you must adjust the
side measurement to centre the
appliance.
ENGLISH 29