Table of Contents
Advertisement
Installation
Starting the E5070B/E5071B
Starting the E5070B/E5071B
This section describes how to turn on/off the E5070B/E5071B power, how to cut off the
power supply in an emergency, and how to set the internal clock.
Turning the Power ON and OFF
Perform the following steps to turn the power ON or OFF.
Turning the Power ON
Step 1. If the standby switch (
(
Step 2. Press the standby switch to put it in the depressed position (
This operation turns ON the power, and the E5070B/E5071B starts the self-test.
Step 3. Confirm that the self-test indicates normal operation.
Normal operation is confirmed by the self-test if no error message appears.
Turning the Power OFF
Step 1. Use either of the following methods to turn the power OFF.
•
•
These operations will start the E5070B/E5071B shutdown process (required software and
hardware processes for turning the power off), and the power will turn OFF after a few
seconds.
NOTE
Under normal circumstances, always press the standby switch (
command from an external controller, to execute the E5070B/E5071B shutdown process.
Never cut off the power supply directly by disconnecting the power cable plug from
the rear panel of the unit.
If the power supply is cut off directly by disconnecting the power cable plug from the
instrument or the AC outlet, the shutdown process is not carried out and there is a risk of
damage to the E5070B/E5071B's software or hardware.
34
) in the lower-left part of the front panel is in the depressed
) position, press it to put it in the popped up position (
Press the standby switch (
pressed down (
) position) to put it in the popped up (
Send the shutdown command from an external controller.
) in the lower-left part of the front panel (now in the
).
).
) position.
), or send the shutdown
Chapter 2
Hide quick links:
Advertisement
Table of Contents
