Aileron And Flap Pushrod Installation; Elevator Pushrod Installation; Rudder Pushrod Installation - Freewing 80mm A-10 User Manual

Accessories Description

Aileron and Flap pushrod Installation

1.Use a servo tester or a
transmitter to center the servo.
2.Use glue to install the servo and
aileron horn to the main wing.
3.Feed the servo cable through
the trough, when completed for
all the servos, apply the decal
over the trough.
Insert one end of the pushrod into
4.
the servo arm and adjust its
length. And secure the clevis to
the aileron horn.
Repeat the above four steps to
5.
install the other clevis' for the flap,
then repeat the procedure for the
other aileron and flap servo.

Elevator pushrod Installation

1.Use a servo tester or a transmitter
to center the servo.
2.Use glue to install the servo and
elevator horn on the elevator.



3.Feed the servo cable through the
trough, when completed for all the
servos, apply the decal over the
trough.
4.Insert one end of the pushrod into
the servo arm and adjust its
length. Secure the clevis to the
elevator horn.
5.Repeat the above four steps for
the other side of the elevator.

Rudder pushrod Installation

1.Use servo tester or a transmitter
to center the servo.
2.Use glue to install the servo and
rudder horn on the rudder.
3.Feed the servo cable through the
trough, when completed, apply
the decal over the trough.
4.Insert one end of the pushrod into
the servo arm and adjust its
length. Secure the clevis to the
rudder horn.
5.Repeat the above four steps for
the other rudder.
13
Note: ： There is a EPO glue on
package, Please use it to glue.
Glue should be spread evenly
and wait for 90 seconds.Then
install on, its best glue condition.
C
B
A-
Servo
B- Main wing pushrod
C- Aileron horn
D- Main wing servo trough
D
B
A
A-
B-
A
C-
C
Servo
Elevator pushrod
Elevator horn
A-
Servo
B- Rudder pushrod
C- Rudder horn
A-10 Thunderbolt II
Item No.:FJ311