Front Light Group - PIAGGIO Beverly Tourer 300ie User Manual

Power: 12V - 5W

Front light group (03_26, 03_27, 03_28, 03_29, 03_30)

To remove the front headlight assembly, proceed as follows:
1. Remove the screws «A» of the brake fluid reservoir caps.
2. Remove the 3 windshield screws and the windshield proper.
3. Remove the rear-view mirrors.
4. Remove the screws "C" of the upper coupling.
5. Remove the screws "C" of the lower coupling.
03_26
6. Remove the two screws "D" of the front handlebar cover.
7. Detach the front handlebar cover.
This gives access to the bulbs.
Release the spring and take out the bulb of the high-beam/low-beam headlamp «E».
To replace the tail light «F», pull out the rubber bulb holder from its seat.
To reassemble, repeat the operation but in reverse order.
WARNING
03_27
THE TWIN-FILAMENT (HIGH-BEAM AND LOW-BEAM) BULB IS HALOGEN: DO
NOT TOUCH THE BULB WITH YOUR FINGERS TO AVOID COMPROMISING ITS
FUNCTIONING
58