Grandstream Networks GXP1610 Administration Manual page 53

Confirm Password
Current Password
New Password
Confirm Password
Maintenance  Upgrade and Provisioning
Firmware Upgrade and
Provisioning
Always Authenticate
Before Challenge
Validate Hostname in
Certificate
Allow DHCP Option 43
and Option 66 to
Override Server
Additional Override
DHCP option
Allow DHCP Option
120 to override SIP
Server
3CX Auto Provision
Automatic Upgrade
Hour of the Day (0-23)
Day of the Week (0-6)
Disable SIP NOTIFY
Authentication
Confirms the end user password field to be the same as above.
Determines the current password which is required to set a new admin
password.
Allows users to change the admin password. The password field is purposely
hidden for security purpose.
This field is case sensitive with a maximum length of 30 characters.
Confirms the admin password field to be the same as above.
Specifies how firmware upgrading and provisioning request to be sent: Always
Check for New Firmware, Check New Firmware only when F/W pre/suffix
changes, Always Skip the Firmware Check.
Only applies to HTTP/HTTPS. If enabled, the phone will send credentials
before being challenged by the server.
To validate the hostname in the SSL certificate.
Default setting is "Yes". DHCP option 66 originally was only designed for TFTP
server. And then was extended to support an HTTP URL. GXP phones support
both TFTP and HTTP server via option 66. Users can also use DHCP option
43 vendor specific option to do this. DHCP option 43 approach has priorities.
Additional DHCP Option that will be used as a firmware server instead of the
setting one or name server from option 43 and 66. However, this option will be
effective only when option 'Allow DHCP Option 43 and Option 66 to Override
Server' is enabled, the options are 150 and 160.
Enables DHCP Option 120 from local server to override the SIP Server on the
phone. The default setting is "No".
Enables automatic provisioning using PnP.
If enabled, the phone will start sending a SIP SUBSCRIBE message to a
multicast IP address 224.0.1.75 at boot up. The phone should receive
response message 200 or 500 from the server, followed by a SIP NOTIFY
including URL from where to download configuration file to get provisioned.
The default setting is "Yes" (Enabled).
Enables automatic upgrade and provisioning. The default setting is "No".
Defines the hour of the day to check the HTTP/TFTP server for firmware
upgrades or configuration files changes. The default value is 1.
Defines the day of the week to check HTTP/TFTP server for firmware upgrades
or configuration files changes. The default value is 1.
Device will not challenge NOTIFY with 401 when set to Yes.
GXP16XX Administration Guide
Version 1.0.4.100
P a g e | 52