Grandstream Networks GXP1610 Administration Manual page 41

Disable Direct IP Call
Use Quick IP Call mode
Disable Conference
Disable in-call DTMF
Display
Enable Sending DTMF
via specific MPKs
Mute Key Functions
While Idle
Disable Transfer
In-call Dial Number on
Pressing Transfer Key
Auto-Attended Transfer
Attended Transfer
Mode
Do Not Escape #
as %23 in SIP URI
Click-To-Dial Feature
Call History Flash
Writing: Write Timeout
Max Unsaved Log
User-Agent Prefix
Predictive Dialing
Feature
there is a new incoming call during an active call. If set to No, the user will hear
call waiting tone. If set to Yes, the phone will ring using the speakerphone.
Disables Direct IP Call. The default setting is "No".
When set to "Yes", users can dial an IP address under the same LAN/VPN
segment by entering the last octet in the IP address. To dial quick IP call,
Offhook the phone and dial #XXX (X is 0-9 and XXX <=255), phone will make
direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP
address REGARDLESS of subnet mask. #XX or #X are also valid so leading 0
is not required (but OK). No SIP server is required to make quick IP call.
The default setting is "No".
Disables the Conference function. The default setting is "No".
When it's set to "Yes", the DTMF digits entered during the call will not display.
The default setting is "No".
Allows certain MPKs to send DTMF in-call. This option does not affect Dial
DTMF.
When set to "DND", the DND will be enabled for future incoming call if pressing
MUTE key in idle state; If this feature is set to "Idle Mute", MUTE key will take
effect in idle state and future incoming call will be answered with mute;
Otherwise, MUTE key will not take effect in idle state.
Disables the Transfer function. The default setting is "No".
Configures the number for the phone to dial as DTMF during the call using
TRAN button.
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
When "Attended Transfer Mode" is set to "Static", only "Blind Transfer" softkey
is available on the call screen. If set to "Dynamic", both "Blind Transfer" and
"Attended Transfer" softkeys are available.
Specifies whether to replace # by %23 or not for some special situations. The
default setting is "No".
Enables Click-To-Dial feature. The default setting is "Disabled".
Defines the interval (in seconds) to save the call history to phone's flash. The
default value is 300 seconds.
Defines the number of unsaved logs before written to phone's flash. The default
value is 200 entries.
Add a prefix in the User Agent field on the SIP header.
Allows the phone to use your dialed number and search the compatible
numbers from history and phonebook and will "Predict" the number you are
going to dial when this feature is enabled. This saves time for the user so they
GXP16XX Administration Guide
Version 1.0.4.100
P a g e | 40