Mounting The Dome Camera To A Pipe - Avigilon 1.3C-H4SL-D1 Installation Manual

connector then push the cable through the grommet.
Ensure that the orientation of the cable and grommet matches the one shown in the image.

Mounting the Dome Camera to a Pipe

If the dome camera needs to be installed to a pipe for a pendant installation, you can discard the surface mount
adapter that is provided with the dome camera and use the NPT adapter.
NOTE: This procedure requires a 1-1/2" NPT-female to NPT-female pipe adapter. It is recommended that the
NPT adapter be mounted to a 1-1/2" conduit pipe.
1. Pull the required cable through the NPT conduit pipe.
2. Apply thread seal tape to the pipe and screw on the 1-1/2" NPT female to NPT female pipe adapter.
3. Screw the lock nut onto the NPT adapter.
4. Apply thread seal tape to the NPT adapter and screw it into the pipe adapter.
Make sure the parts are assembled in this order from NPT conduit pipe to camera adapter:
a. NPT conduit pipe
b. 1-1/2" NPT female to female pipe adapter
c. Lock nut
d. NPT adapter

Mounting the Dome Camera to a Pipe

11