Horizontal Surface Mounting - Delta AG6248C Installation Manual

3. If installing a single switch only, go to " Connecting to a Power Source ".
4. If installing multiple switches, mount them in the rack, one below the other, in any order.

3.1.2 Horizontal Surface Mounting

The switch includes four pre-installed rubber feet for horizontal surface mounting.
To mount devices on a horizontal surface, follow these steps:
1. Attach the four adhesive feet to the bottom of the first switch.
2. Set the device on a flat horizontal surface near an AC power source, making sure there are
at least two inches of space on all sides for proper air flow.
3. If installing a single switch only, go to " Connecting to a Power Source ".
4. If installing multiple switches, attach four adhesive feet to each one, then place each device
squarely on top of the one below, in any order.
AG6248C Power-Over-Ethernet Switch
CAUTION:
Due to the switch's weight, it should be installed by at least two people.
(Figure 3-2: Installing the Switch in a Rack)
(Figure 3-3: Attaching the Adhesive Feet)
11