Connecting To The Console Port; Connecting To A Power Source - Delta AG6248C Installation Manual

3.3

Connecting to the Console Port

This port is used to connect a console device to the switch through a nullmodem serial cable.
The console device can be a PC or workstation running a VT-100 terminal emulator, or a
VT-100 terminal. An RJ-45-to-DB-9 cable is supplied with the switch for connecting to a PC's
RS-232 serial DB-9 DTE port. The pin assignments used in the RJ-45-to-DB-9 cable are
described below.
3.4

Connecting to a Power Source

To connect a switch to a power source:
1. Insert the power cable plug directly into the AC socket of a PSU located at the back of the
switch.
2. Plug the other end of the cable into a grounded, 3-pin, AC power source.
AG6248C Power-Over-Ethernet Switch
DP-9 port
(Figure 3-5: Console Port Connection)
NOTE:
For International use, you may need to change the AC line cord. You must use a
line cord set that has been approved for the socket type in your country.
RJ-45 connector
Power socket
(Figure 3-6: Power Socket)
13