Samson 3730-3 Operating Instructions Manual page 119

Code Parameter – Readings/
No. values [default setting]
Codes with marked with an asterisk (*) must be enabled with Code 3 prior to configuration.
F3 Simulate
48* AO Function Block
A0 Target mode
A1 Actual mode
A2 CAS_IN value
A3 CAS_IN status
A4 SP value
A5 SP status
A6 Out value
A7 Out status
A8 Block error
PID Function Block (PID)
P0 Target mode
P1 Actual mode
P2 CAS_IN Value
P3 CAS_IN Status
P4 SP value
P5 SP status
P6 Out value
P7 Out status
P8 Block error
Transducer Blocks A0, DI1, DI2
t0 Target mode AO Trd
t1 Actual mode AO Trd
t2 Transducer state
t3 Block error AO Trd
EB 8389 EN
Description
Activation of simulation mode
Target operating mode
Current operating mode
Analog set point adopted from an upstream function block and its
status
Set point and its status
Manipulated variable (output value) and its status
Current block error
Target operating mode
Current operating mode
Analog set point adopted from an upstream function block and its
status
Set point and its status
Manipulated variable (output value) and its status
Current block error
Target operating mode
Current operating mode
State of the Transducer Block
Current block error
Appendix
119