Samson 3730-3 Operating Instructions Manual page 116

Appendix
Code Parameter – Readings/
No. values [default setting]
Codes with marked with an asterisk (*) must be enabled with Code 3 prior to configuration.
48* F3 Device start up counter
F4 Reset communication
controller
F5 Reset closed-loop
controller counter
F6 Reset bus connection
counter
F7 Slave state
AO Function Block A
A0 Target mode
A1 Actual mode
A2 SP value
A3 SP status
A4 Readback value
A5 Readback status
A6 Out value
A7 Out status
A8
A9 Simulate
Transducer Blocks A0, DI1, DI2 t
t0 Target mode AO Trd
t1 Actual mode AO Trd
116
Description
0 Not defined
1 wait_cfg
2 wait_prm
3 data_exchg
Desired operating mode
Current operating mode
Set point (reference variable) and its status
Current position and its status
Manipulated variable (output value) and its status
Positioner simulation
0 Blocked
1 Released
Desired operating mode
Current operating mode
1)
1)
1)
1)
EB 8389 EN