Configuring 1-To-1 Vcc Cell Transport Pseudowire - Cisco ASR 900 Series Configuration Manual

Configuring the ATM over MPLS Pseudowire Interface
When creating IP routes for a pseudowire configuration, build a route from the xconnect address (LDP
Note
router-id or loopback address) to the next hop IP address, such as ip route 10.10.10.2 255.255.255.255
10.2.3.4.

Configuring 1-to-1 VCC Cell Transport Pseudowire

A 1-to-1 VCC cell transport pseudowire maps one ATM virtual channel connection (VCC) to a single
pseudowire. Complete these steps to configure a 1-to-1 pseudowire.
Multiple 1-to-1 VCC pseudowire mapping on an interface is supported.
Note
Mapping a Single PVC to a Pseudowire
To map a single PVC to an ATM over MPLS pseudowire, use the xconnect command at the PVC level. This
configuration type uses AAL0 and AAL5 encapsulations. Complete these steps to map a single PVC to an
ATM over MPLS pseudowire.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface ATM slot / IMA group-number
4. pvc slot/subslot l2transport
5. encapsulation aal0
6. xconnect router_ip_address vcid encapsulation mpls
7. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
30
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Configuring Pseudowire