Configuring Pseudowire
This chapter provides information about configuring pseudowire (PW) features on the router.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Pseudowire Overview
The following sections provide an overview of pseudowire support on the router.
Pseudowire Overview, page 1
Limitations, page 7
Configuring CEM, page 8
Configuring CAS, page 14
Configuring ATM, page 17
Configuring Structure-Agnostic TDM over Packet (SAToP), page 21
Configuring Circuit Emulation Service over Packet-Switched Network (CESoPSN), page 23
Configuring a Clear-Channel ATM Pseudowire, page 24
Configuring an ATM over MPLS Pseudowire, page 26
Configuring an Ethernet over MPLS Pseudowire, page 37
Configuring Pseudowire Redundancy, page 39
Pseudowire Redundancy with Uni-directional Active-Active , page 41
Restrictions , page 42
Configuring Pseudowire Redundancy Active-Active— Protocol Based, page 43
Configuring the Working Controller for MR-APS with Pseudowire Redundancy Active-Active, page
43
Configuring the Protect Controller for MR-APS with Pseudowire Redundancy Active-Active, page 44
Verifying the Interface Configuration, page 44
Configuration Examples, page 45
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
1
C H A P T E R
1