Cisco ASR 900 Series Configuration Manual page 88

Verifying MR-APS
Local interface: CEM0/5/2
• Use the show hspw-aps-icrm group group-id command to display information about a specified HSPW
APS group:
Router# show hspw-aps-icrm group 100
ICRM group id 100, Flags : My core isolated No,Peer core isolated No,
State Connect
• Use the show hspw-aps-icrm all command to display information about all HSPW APS and ICRM
groups:
Router# show hspw-aps-icrm all
ICRM group id 100, Flags : My core isolated No,Peer core isolated No,
State Connect
attached to MR-APS HSPW feature is 1
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
80
Destination address: 17.3.3.3, VC ID: 1001, VC status: up
Output interface: Gi0/4/0 , imposed label stack {42}
Preferred path: not configured
Default path: active
Next hop: 11.11.11.2
Create time: 00:26:04, last status change time: 00:03:36
Last label FSM state change time: 00:23:00
Signaling protocol: LDP, peer 17.3.3.3:0 up
Targeted Hello: 17.1.1.1(LDP Id) -> 17.3.3.3, LDP is UP
Graceful restart: configured and enabled
Non stop routing: not configured and not enabled
Status TLV support (local/remote)
LDP route watch
Label/status state machine
Last local dataplane
Last BFD dataplane
Last BFD peer monitor
Last local AC
Last local AC
Last local PW i/f circ status rcvd: No fault
Last local LDP TLV
Last remote LDP TLV
Last remote LDP ADJ
MPLS VC labels: local 182, remote 42
Group ID: local 0, remote 0
MTU: local 0, remote 0
Remote interface description:
Sequencing: receive disabled, send disabled
Control Word: On (configured: autosense)
SSO Descriptor: 17.3.3.3/1001, local label: 182
Dataplane:
SSM segment/switch IDs: 1278679/4262 (used), PWID: 1
VC statistics:
transit packet totals: receive 201616, send 201617
transit byte totals:
transit packet drops:
APS Group id 1 hw_if_index 33 APS valid:Yes
Total aps grp attached to ICRM group 100 is 1
APS Group id 1 hw_if_index 33 APS valid:Yes
Total aps grp attached to ICRM group 100 is 1 ICRM group count
Configuring Multi Router Automatic Protection Switching
up, line protocol up, SATOP T1 1 up
status rcvd: No fault
status rcvd: Not sent
status rcvd: No fault
circuit status rcvd: No fault
circuit status sent: No fault
status sent: No fault
status rcvd: No fault
status rcvd: No fault
receive 41129664, send 40323400
receive 0, seq error 0, send 0
: enabled/supported
: enabled
: established, LruRru