Transparent SONET or SDH over Packet (TSoP) Protocol
Configuration Examples for TSoP
Sample Configuration
For configuring SONET or SDH controller as in the figure (network A and B), see
Interface
Figure 10: TSoP in Packet Switched Network
TSoP Smart SFP inserted in the PE's, CE (SONET or SDH) can be configured as
• SDH or SONET framing for T1 and E1 mode.
• Serial interface in SDH or SONET mode. The scale for OC-3 IM is as supported—63 for E1 and 84 for
• Multilink interface with minimum of 1 member link and maximum of 16 member link.
• POS interface in SDH or SONET mode.
• ATM Layer3 interfaces in SDH or SONET mode.
• In OC-12 mode, if OC-12 IM is used on CE, only port 0 (ZERO) of the IM is used. Use the card-type
For configuring the pseudowire using service instances, see
the Cisco ASR 903
Only untagged encapsulation is supported.
Note
• The following example shows a sample configuration on the CE:
Modules.
T1 interfaces. The scale supported for OC-12 IM is 252 E1 and 336 T1 interfaces.
ATM Layer 3 interface is not supported on CE for OC-12 IM.
Note
command to operate the OC-12 IM.
Router.
!
controller SONET 0/2/3
framing sdh
clock source line
aug mapping au-3
!
!
au-3 1
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
Configuration Examples for TSoP
Configuring Optical
Ethernet Virtual Connections Configuration on
139