Cisco ASR 900 Series Configuration Manual page 28

Configuring ATM IMA
Command or Action
Example:
Step 8
interface ATMslot/subslot/IMA group-number
Example:
Router(config-if)# interface atm0/1/ima0
Step 9
no ip address
Example:
Router(config-if)# no ip address
Step 10 atm bandwidth dynamic
Example:
Router(config-if)# atm bandwidth dynamic
Step 11
no atm ilmi-keepalive
Example:
Router(config-if)# no atm ilmi-keepalive
Step 12 exit
Example:
Router(config)# exit
What to Do Next
The above configuration has one IMA shorthaul with two member links (atm0/0 and atm0/1).
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
20
Purpose
Specify the slot location and port of IMA interface group.
• slot—The location of the ATM IMA interface module.
• group-number—The IMA group.
The example specifies the slot number as 0 and the group number
as 0.
To explicitly configure the IMA group ID for the IMA
Note
interface, use the optional ima group-id command. You
cannot configure the same IMA group ID on two different
IMA interfaces; therefore, if you configure an IMA group
ID with the system-selected default ID already configured
on an IMA interface, the system toggles the IMA interface
to make the user-configured IMA group ID the effective
IMA group ID. The system toggles the original IMA
interface to select a different IMA group ID.
Disables the IP address configuration for the physical layer interface.
Specifies the ATM bandwidth as dynamic.
Disables the Interim Local Management Interface (ILMI) keepalive
parameters.
Exits configuration mode.
Configuring Pseudowire