Configuring The Atm Over Mpls Pseudowire Interface - Cisco ASR 900 Series Configuration Manual

Configuring Pseudowire
Command or Action
Step 5
atm bandwidth dynamic
Example:
Router(config-if)# atm bandwidth
dynamic
Step 6
no atm ilmi-keepalive
Example:
Router(config-if)# no atm
ilmi-keepalive
Step 7 exit
Example:
Router(config)# exit
What to Do Next
For more information about configuring IMA groups, see the

Configuring the ATM over MPLS Pseudowire Interface

You can configure ATM over MPLS is several modes according to the needs of your network. Use the
appropriate section according to the needs of your network. You can configure the following ATM over MPLS
pseudowire types:
•
•
•
•
•
•
Configuring 1-to-1 VCC Cell Transport Pseudowire, on page
pseudowire
Configuring N-to-1 VCC Cell Transport Pseudowire , on page
pseudowire
Configuring 1-to-1 VPC Cell Transport, on page
Configuring ATM AAL5 SDU VCC Transport, on page
ATM PVC
Configuring a Port Mode Pseudowire, on page
connection
Optional Configurations, on page 36
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
Configuring the ATM over MPLS Pseudowire Interface
Purpose
Specifies the ATM bandwidth as dynamic.
Disables the ILMI keepalive parameters.
Exits configuration mode.
Configuring ATM IMA, on page
31—Maps a single VPC to a single pseudowire
33—Maps a single ATM PVC to another
35—Maps one physical port to a single pseudowire
18.
30—Maps a single VCC to a single
31—Maps multiple VCCs to a single
29