Cisco ASR 900 Series Configuration Manual page 89

Configuring Multi Router Automatic Protection Switching
• Use the show redundancy interchassis command to display information about interchassis redundancy
group configuration:
Router# show redundancy interchassis
Redundancy Group 100 (0x64)
ICRM fast-failure detection neighbor table
• Use the show aps command to display information about the current APS feature:
Router# show aps
SONET 0/5/2
• Use the show xconnect all command to display information about all Cross–Connect attachment circuits
and PWs:
Router# show xconnect all
Legend:
XC ST
------+---------------------------------+--+----------------------------
------+---------------------------------+--+---
--+--
UP pri
IA sec
UP pri
IA sec
!
.
.
.
UP pri
Applications connected: MR-APS with HSPW
Monitor mode: RW
member ip: 60.60.60.2 "R-222-2028", CONNECTED
Route-watch for 60.60.60.2 is UP
MR-APS with HSPW state: CONNECTED
backbone int GigabitEthernet0/4/0 : UP (IP)
backbone int GigabitEthernet0/4/2 : UP (IP)
IP Address Status Type Next-hop IP
========== ====== ==== ===========
60.60.60.2 UP
APS Group 1: working channel 1 (Active) (HA)
Protect at 60.60.60.2
PGP timers (from protect): hello time=1; hold time=10
SONET framing
Remote APS configuration: (null)
XC ST=Xconnect State
UP=Up DN=Down
SB=Standby HS=Hot Standby
Segment 1
S2
ac CEM0/5/2 :1(SATOP T1)
UP
ac CEM0/5/2 :1(SATOP T1)
SB
ac CEM0/5/2 :10(SATOP T1)
UP
ac CEM0/5/2 :10(SATOP T1)
SB
ac CEM0/5/2 :9(SATOP T1)
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
RW
S1=Segment1 State
AD=Admin Down
RV=Recovering
S1 Segment 2
UP mpls 17.3.3.3:1001
UP mpls 17.4.4.4:4001
UP mpls 17.3.3.3:1010
UP mpls 17.4.4.4:4010
UP mpls 17.3.3.3:1009
Verifying MR-APS
Interface
=========
S2=Segment2 State
IA=Inactive
NH=No Hardware
81