Wireless (2.4Ghz Or 5Ghz); Wireless Settings; Wps - TP-Link Archer C50 User Manual

Chapter 5
5. 6.

Wireless (2.4GHz or 5GHz)

5. 6. 1.

Wireless Settings

1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Wireless > Basic
3. Configure the basic settings for the wireless network and click Save.
• Wireless - Enable or disable wireless network.
• Wireless Network Name
must be assigned to all wireless devices in your network.
• Mode - You can choose the appropriate "Mixed" mode.
• Channel - This field determines which operating frequency will be used. The default
channel is set to Auto. It is not necessary to change the wireless channel unless you
notice interference problems with another nearby access point.
• Channel Width - This field determines which operating frequency will be used. It is not
necessary to change the wireless channel unless you notice interference problems
with another nearby access point. If you select auto, then AP will choose the best
channel automatically.
• Enable SSID Broadcast
name (SSID).
5. 6. 2.

WPS

WPS (Wi-Fi Protected Setup) can help you to quickly and securely connect to a network.
This section will guide you to add a wireless device to your router's network via WPS.
Note:
The WPS function cannot be configured if the wireless function of the router is disabled. Please make sure the wireless
function is enabled before configuration.
Settings.
- Enter a value of up to 32 characters. The same Name (SSID)
- If enabled, the router will broadcast the wireless network
Configure the Router in Access Point Mode
77