TP-Link Archer C50 User Manual page 24

Chapter 4
• Primary DNS/Secondary DNS
addresses to the router, please select
address in dotted-decimal notation of your ISP's primary DNS server. If a secondary
DNS server address is available, enter it as well.
L2TP
If your ISP provides L2TP connection, please select L2TP.
• Username/Password
fields are case-sensitive.
• Addressing Type - Choose the addressing type given by your ISP, either Dynamic IP
or Static IP. Click the
button to disconnect immediately.
• MTU(Bytes) - The default MTU size is "1460" bytes, which is usually fine. It is not
recommended that you change the default MTU Size unless required by your ISP.
• Enable IGMP Proxy
multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration
for client devices, such as the modem router. The default value is enabled, and if you
are not sure, please contact your ISP or just leave it.
• Connection Mode
• Always On - In this mode, the internet connection will be active all the time.
• Connect on Demand
automatically after a specified inactivity period (Max Idle Time) and be re-
established when you attempt to access the internet again. If you want to keep
- If your ISP does not automatically assign DNS
- Enter the user name and password provided by your ISP. These
Connect button to connect immediately. Click the
- IGMP (Internet Group Management Protocol) is used to manage
- In this mode, the internet connection can be terminated
Configure the Router in Wireless Router Mode
Set DNS server manually and enter the IP
Disconnect
19