Static Ipv6 - TP-Link Archer C50 User Manual

Chapter 4
• Addressing Type
SLAAC (Stateless address auto-configuration) and DHCPv6 (Dynamic Host
Configuration Protocol for IPv6) Server.
• MTU(Bytes)
Ethernet networks is 1500 Bytes. For some ISPs, you may need to modify the
MTU. But this is rarely required, and should not be done unless you are sure it is
necessary for your ISP connection.
If your ISP gives you one or two DNS IPv6 addresses, select Set IPv6 DNS Server
manually and enter the IPv6 DNS Server and Secondary IPv6 DNS Server into the
correct fields. Otherwise, the DNS servers will be assigned from ISP dynamically.
• Enable MLD Proxy
function if you need.
• IPv6 DNS Server
• Secondary IPv6 DNS Server
your ISP.
Note:
If you get Address not found error when you access a website, it is likely that your DNS servers are set up improperly.
You should contact your ISP to get DNS server addresses.

Static IPv6

• IPv6 Address
• Prefix Length
• IPv6 Gateway
• IPv6 DNS Server
• Secondary IPv6 DNS Server
your ISP.
• MTU(Bytes)
Ethernet networks is 1500 Bytes. For some ISPs, you may need to modify the
- There are two types of assignation for IPv6 address:
- The normal MTU (Maximum Transmission Unit) value for most
- Enable the Multicast Listener Discovery (MLD) Proxy
- Enter the DNS IPv6 address provided by your ISP.
- Enter another DNS IPv6 address provided by
- Enter the IPv6 address provided by your ISP.
- The length of IPv6 address prefix.
- Enter the default gateway provided by your ISP.
- Enter the DNS IPv6 address provided by your ISP.
- Enter another DNS IPv6 address provided by
- The normal MTU (Maximum Transmission Unit) value for most
Configure the Router in Wireless Router Mode
60